Development Of Hand Press To Power Press Using Quick Return Mechanism


EOI: 10.11242/viva-tech.01.06.003

Download Full Text here



Citation

Mr. Vinit Raut, Mr. Aniket Malankar, Mr. Nilesh Mane, Mr.Ravikumar Jayswal, "Development Of Hand Press To Power Press Using Quick Return Mechanism", VIVA-IJRI Volume 1, Issue 6, Article 3, pp. 1-5, 2023. Published by Computer Engineering Department, VIVA Institute of Technology, Virar, India.

Abstract

The power press is an important machine tool that is used to changes in the shape of metal. In ancient times metal was shaped manually using hand hammers. Later on, big hammers were used to press large quantities of metal at a time, or to press a thick metal work piece. the helper is specially required to swing the sledgehammer while smith positioned the workpiece. Then after the steam power and wind mills were utilized to the operate large steam hammers. Later on, due to the electrification is most of the power presses are now use electrical power or hydraulic power to obtain the required pressure. The flywheel is a heavy rotating mass which is placed between the power source and driven machine to act as a reservoir of energy. It is used to the store energy when the need of energy and energy is less for the deliver it when the need of energy is high. The current paper is focused on the analytical design of arm type of flywheel which is used for the punching press operation. They are analyzed to improve the performance and quality for press working operation. Cost and material choices are relayed along with a complete set of engineering drawings for the manufacture of the press. Testing and failure modes are the analyzed with an overall goal of customer safety in mind.

Keywords

Hand press, h-frame, design, die, power press, flywheel

References

  1. Punch Press Services Ltd http://www.punchpressuk.com/page/10091/article/668
  2. Press Brakes, Pacific Press Technologies Web site (http://www.pacific-press.com/brakes.html Archived 2014-04-11 at the Wayback Machine). Retrieved 7-26-14.
  3. Press Brake Tonnage Table, American Machine Tools Co. Web site (http://www.americanmachinetools.com/pressure_table.htm Archived 2018-08-15 at the wayback Machine). Retrieved 7-26-14.
  4. Kestner K. Mihai Talu, Modular design of a hydraulic press, Publisher: University of Missouri-Columbia, 2004.
  5. Q.S.KHAN, S. P. Patel “Introduction to hydraulic presses & press body” volume-1, tanveer publications, Vol. 4, Issue 09, 2016 | ISSN (online): 2321-0613 S M Choudhary “Design and Optimization of Flywheel – A Past Review” IJMERR/Vol.1,Issue.XII/June 2012pp.1-4